N20 Motor with MicroFlip V2 Shopify Collective Attribute Accepted Value(s) [Our Recommended

Attribute Accepted Value(s) [Our Recommended Value] Extruder Temperature 250-280 Degrees Celsius [270] Heated Bed 100-120 Degrees Celsius [110] Build Surface PEI

To prevent moisture absorption and contamination

Check out our other lines of Ambrosia Filament

16KG) ISO 1133 4-8 g/10min Mechanical Properties Test Methodology Values Tensile Strength ISO 527 45-49 Mpa Elongation at break ISO 527 13-15

N20 Motor with MicroFlip V2 Shopify Collective Attribute Accepted Value(s) [Our RecommendedThese are 6v 15rpm N20 motors specced for the Goose Belt Purger project. These motors measure approximately 130 ohms of resistance, as such your PWM control should be increased for best results. MicroFlip pre soldered onto the motors for your convenience. JST PH connector + pins included.